Belt Slide Mount

Our Belt Slide Mount fits belts from 1.5 to 1.75 inches. The super tough, one piece design is made with mold injection nylon and is adjustable for ride height and draw cant.

Installation

Start with threaded post through bottom hole. Set with O-ring.

Line up the mount over the threaded post. Add thread locker if available. Loosely set screw.

Hold threaded posts through the holster's upper mounting holes. Slip O-rings between holster body and mount.

While holding threaded posts, set screws though the mount. Apply thread locker if available. Securely tighten all screws.

---